Mootoririhma pingutamine
Sellelt lingilt lugesin, kuidas peaks rihma pingutama. Jäi segaseks, kuidas pingutatakse balansiiride rihma. Kas idle rullik on peal või mitte. Saatsin meili ja küsisin järgi.joonas kirjutas: Siis on mingi Optibelt, mis on sarnane krikit-iga.
http://www.blaszakprecision.com/Belts.html
Actually NO. I had to take the roller off so the camera angle would work, else all you could see was the roller and not the tool.
Tension with the roller in place.... and check mid span between the roller and the upper sprocket. When measuring make sure the tool is ON a tooth of the balance belt.
Markus Blaszak
Blaszak Precision Motorsports
4835 Holmes Road
Inverary, ON, Canada
K0H1X0
613-353-7012 EST
http://www.BlaszakPrecision.com
Sent: April 2, 2007 3:31 AM
To: mblaszak@kos.net
Subject: Question about belt tensioning procedure
Hi
I looked at your webpage and found belt tensioning instructions.
http://www.blaszakprecision.com/Belts.html
Do not forget to adjust the balance shaft belt idler roller. It requires 1mm preload on the belt on the top side and 0.5mm gap at the lower balance shaft location. This should be done BEFORE setting the final tension on the balance shaft belt.
When I look added pictures I see that mechanic measures the balance shaft belt tension when the idle roller is off. The write-up above says that you should adjust the idle roller first and then set/measure the belt tension.
When and were should I measure balance shaft tension.
Natuke juttu ka siin http://joonas.pri.ee/cms/index.php?page=krikit